Authors: Carole Jordan and Keith Macpherson
(Oxford), Richard Harrison (CDS),
Bob Stern (EIT), Julia Saba (MDI), Philippe Lemaire (SUMER)
E-mail Addresses:
cj@astro.ox.ac.uk, kpm@thphys.ox.ac.uk,
harrison@solg2.bnsc.rl.ac.uk, stern@sag.space.lockheed.com
saba@mdisas.nascom.nasa.gov, lemaire@sumop1.nascom.nasa.gov
Progress:
Original Version:- April 1997
Updated Version:- September 23rd, 1997
Objective:
To investigate the systematic behaviour of He I and He II line fluxes
in comparison with atmospheric models determined from other transition
region lines.
Conditions necessary to run:
The presence of two `quiet' regions along the central meridian, and a
coronal hole at either the north or south pole. Involvement of at least
CDS and SUMER. Availability of synoptic full-disk EIT images close to
time of CDS/SUMER sequences, plus synoptic full-disk MDI magnetograms
preferred.
In a later paper Jordan (1980, Phil. Trans, Roy. Soc. London A297, 541) discussed how the enhancements might depend on measurable transition region parameters (electron pressure, temperature gradient, non-thermal velocities) and stressed that dynamic effects must be taken into account. The second aim is to test the correlations proposed by using also the widths of the Si IV and O IV] lines observed with SUMER.
Observations with the EIT will give the type of structure in and around the field of view to be observed. Coincident MDI spectrograms would give information on the magnetic field which has so far not been available in the context of the helium lines.
For the Joint CDS/SUMER observations, three locations should be observed along the central meridian; a quiet region at (or near) Sun centre, quiet region at a mid-latitude, and the third region near the limb, to include a coronal hole. The direction away from Sun-centre (N or S) should be decided to give the best coronal hole coverage.
MDI and EIT to provide details on the overall type of regions studied. CDS to observe two further quiet regions on solar equator, midway to limb and near the limb, without SUMER support.
(i) CDS Sequence HELIUM: NIS 2" x 240" slit, at 20 raster locations, to cover 40" raster width. Exposure time, 70 s at each location. 30 pixel width for each line. 15 lines, (where blends occur central wavelength of required region is given) as follows: He I (537.030 A), He I (584.334 A), He II (303.783 x 2 = 607.566 A), O III (525.795 A), O III (599.598 A), O IV (553.330 A), O IV (554.514 A), O IV (608.390 A), O V (629.730 A), Ne IV (543.891 A), Ne V (572.34 A), Ne VI (562.80 A), Mg IX (368.071 A), Mg X + O IV (609.79 A), Mg X (624.95 A).
(ii) SUMER: Slit 4, 1" by 120" area. Reference pixel 1: 600 on detector A; spectral window 25 pix. Line centering to cover 1387.44 to 1408.52 on KBr to provide Si IV lines plus O IV lines (including O IV 1407.39). Precise exposure time to be determined but will be much less than for CDS exposures.
(iii) EIT: Images in He II and Fe IX/X would be useful for determining type of region studied in detail.
(iv) MDI: Either full disk magnetogram or the high spatial resolution MDI mode images would allow relation between magnetic field and helium enhancement to be studied for first time.
Joint CDS/SUMER observations: three locations should be observed along the central meridian; a quiet region at (or near) Sun centre, quiet region at a mid-latitude, and the third region near the limb, to include a coronal hole. The direction away from Sun-centre (N or S) should be decided to give the best coronal hole coverage.
At each location, run CDS sequence HELIUM twice, once in conjunction with SUMER Sequence 1 and once with SUMER Sequence 2. See Updated Operating Details below for specific details of CDS and SUMER sequences.
MDI and EIT to provide details on the overall type of regions studied.
No other individual runs of CDS-HELIUM on the solar equator required, unlike original operating procedure.
(i) CDS: No change to CDS sequence HELIUM given originally. Sequence duration ~25 mins. Run twice at each of the 3 solar locations, firstly in conjunction with new SUMER Sequence 1, then repeated but this time with SUMER Sequence 2 (detailed below).
(ii) SUMER: Two sequences to run at each location, in conjunction
with the two runs of CDS HELIUM study at each solar location.
Sequence 1:
Sequence 2:
Practical Implementation: To minimise the number of slit changes required, we suggest the following sequence.
1st location: Start run of CDS-HELIUM with SUMER Sequence 1 in
line list order (1), (2), (3).
Repeat run of CDS-HELIUM, SUMER Sequence 2
with line list order (3), (2), (1)
2nd location: CDS-HELIUM with SUMER Sequence 1, line list order (1),
(2), (3).
Then CDS-HELIUM with SUMER Sequence 2, line list order (3), (2),
(1)
3rd location: CDS-HELIUM with SUMER Sequence 1, line list order (1),
(2), (3).
Then CDS-HELIUM with SUMER Sequence 2, line list order (3), (2),
(1)
(iii) EIT: Full disk images in He II 304 plus coronal lines would allow us to study the larger structure around the regions studied in detail.
(iv) MDI: As before